Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may find that your garage door opener has actually been providing you problems, so you need to repair it. You can fix it by replacing a circuit board, a photo-eye sensor, the major drive equipment, or the set-limit buttons. You can additionally examine if the safety sensors are working correctly.

Replacing a circuit board

Changing a circuit card for your garage door opener requires a couple of actions and also tools. First, you need to shut off the circuit breaker and detach any kind of wires. Next off, open up the circuit board cover. This will help you to diagnose the issue as well as determine if you require a brand-new board. Next, remove the old board and its cord ports.

You can then proceed to replace the circuit board. The replacement process is easy and takes about 10 mins. A new motherboard will cost concerning $80. To secure your new motherboard from power surges, you can acquire a surge protector.

Replacing a photo-eye sensor

Changing a photo-eye sensing unit can be a relatively easy job. Initially, eliminate the sensing unit from the door as well as see to it is located properly. If the sensing unit is angled by any means, it may not be getting the proper signal, which might be creating the strobe lights. If you observe that the photo-eyes run out placement, you may require to have actually a professional come and take care of the trouble.

The photo-eye sensing unit includes 2 pieces that install outside of the door tracks and toward the flooring. The photo eyes will certainly have a small LED light and also must be solid in shade. If the light is blinking, its most likely the photo-eye is defective as well as will certainly require to be changed.

Replacing a main drive gear

To change a garage door opener main drive equipment, begin by eliminating the cap from the chain pulley. Next, remove both screws holding the drive equipment to the gear setting up. Currently, you can loosen the three stress pins. Press them from both sides and after that remove them. After that, separate the three cables from the garage door opener motor. These cords need to be white, red, and also blue.

As soon as you have eliminated the old gear, set up a brand-new one. Make sure to grease it well. Put the brand-new equipment right into the shaft, ensuring to line up the installing holes. Ensure the equipment and gear assembly are positioned properly to ensure smooth operation. Next, utilize a hammer as well as a nail to drive a pin right into the new gear.

Adjusting the set-limit buttons

The first thing you should do if your garage door is not functioning properly is to examine the set-limit buttons. You may need to readjust them so that the door closes earlier or stops before it gets to the floor. You can check this by taking a look at your garage doors handbook or online.

To adjust the set-limit buttons, youll need a screwdriver or outlet. Readjust the knob clockwise or counterclockwise up until the door goes up and also stops, or decreases its range. To check for correct travel distance, gauge the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Garage Door Opener Repair You may find that your garage door opener has actually been providing you problems, so you need to repair it. You can fix it by replacing a circuit board, a photo-eye sensor, the major drive equipment, or the set-limit buttons. You can additionally examine if the safety sensors are working correctly.…

Leave a Reply

Your email address will not be published. Required fields are marked *